Carprog V8.21 With All 21 Adapters user manual

Here is an user manual for Carprog V8.21 With All 21 Adapters

1

Powering up the carprog full v8.21:

2

CarProg can be used with external power supply (+7 – +12V stabilized), only with USB connection or with diagnostic cable ( for ex. OBDII)

Standard power socket (positive in the middle) voltage in range +7…14V stabilized can be used in any cases. Use it when +12V voltage is required(Transponder read/write, some MCU`s read/write)

 

USB power from PC – 5V, 100mA:

3

Always must be connected because USB cable is used for Device – PC communication. Is enough for small power consumption

operations (i.e. EEPROM read/write)

 

Using standard Car diagnostic Cable

4

 

Installing Carprog software:

Copy software from CD or from your support page on

www.codecard.lt to any directory on your PC. Main CarProg file can be older version, just click on Update-Internet and CarProg will by updated automatically.

5

After update CarProg software must restart automatically and CarProg hardware update must be done. Don’t disconnect CarProg USB cable while update process. If updates fail,try again.

6

7

8

9

10

https://www.obd2tool.com/blog/2019/04/04/carprog-v8-21-with-all-21-adapters-user-manual/

Author: Eva

Leave a Reply

Your email address will not be published. Required fields are marked *