Tag Archive: GM Tech II

GM Tech2 for ALL systems – HP Tuners only for ECM & TCM

What is GM Tech2: The GM Tech2 Scanner, working with TIS2000 software, supports onboard diagnostics and full bi-directional control when performing powertrain, chassis and body diagnostics for GM/SAAB/OPEL/SUZUKI/ISUZU/Holden. What is HP Tuners: The HP Tuners vcm suite is the most…
Read more

same problem as recording images to the memory card via the Tech 2 and TIS

Hello everyone. A few days ago saw that often face the same problem as recording images to the memory card via the Tech2 Scan Tool and TIS. Initially I thought this is a typical problem with MAX232, only a little deeper,…
Read more

What can I do with a GM Tech2 on Chevrolet C5

This is a write-up for those with a GM Tech 2 Scan Tool on Chevrolet C5 Tech 2 scanner is a diagnostic tool for the most part. It can be used to program out/in certain RPO’s in the BCM and can…
Read more

Control Module Stand-Alone Programming Adapter (J-45211) for Cadillacs

The J-45211 control module stand-alone programming adapter (Figure VIIC-41), also called the PCM programming adapter harness, is used to connect the Tech 2 to a vehicle’s PCM and perform SPS functions for the 2000 or later Cadillac models DeVille, Seville,…
Read more

GM Tech2 Initial Hardware Installation

The GM Tech2 hardware initial installation requires the following seven tasks: 1.  Remove the RS-232 loopback adapter (P/N 3000112) from the storage case (P/N 3000116). Plug it into the RS-232 port. 2.  Attach the Tech 2 DLC cable (P/N 3000095) to…
Read more

Unlock Chevy TrailBlazer radio using GM Tech2 scanner

I have successfully unlocked the radio on my Chevy TrailBlazer with a clone Tech 2 Scan Tool from China yesterday. Here I would like to share the procedure. If you also like to unlock the radio, please complete the following procedure,…
Read more

How to Program Cadillac key fob with GM Tech2 clone

This is an instruction on how to program key fob to 2007 Cadillac CTS-V using a Tech 2 Scanner Tech II scanner. Model: 2007 Cadillac CTS-V The process…here you go… The key to be programmed Insert the key and ignition on…
Read more

GM Tech2 clone program ECU with SPS in TIS2000

Here is the step-by-step instruction on programming GM (General Motors) ECUs with Tech2 scanner and SPS (Service Programming System) application in TIS2000. NOTE: Before using the SPS, make sure that the GM Tech 2 Scan Tool and the pc contain the…
Read more

How to solve 2009 Saab 9-3 1.9 TID non starter by GM TECH 2 ?

This post starts with the problem that 2009 Saab 9-3 1.9 tid no starter, then how to solve? Please go on reading following parts. Car model and year: 2009 Saab 9-3 1.9 tid General Car issue: non starter Tool I…
Read more

GM Tech 2 Scanner Program TCM Buick Enclave 2008

Hi, all. Today www.obd2tool.com would update tech 2 scanner tested reports, which GM Tech2 was used to program transmission control module (TCM) for my Buick Enclave 2008 with a mileage of 16,000km. tech 2 used: Pictures about programming TCM: