Tag: tech 2 scanner
GM Tech2 clone program ECU with SPS in TIS2000
Here is the step-by-step instruction on programming GM (General Motors) ECUs with Tech2 scanner and SPS (Service Programming System) application in TIS2000. NOTE: Before using…
How to solve 2009 Saab 9-3 1.9 TID non starter by GM TECH 2 ?
This post starts with the problem that 2009 Saab 9-3 1.9 tid no starter, then how to solve? Please go on reading following parts. Car…
GM Tech 2 Scanner Program TCM Buick Enclave 2008
Hi, all. Today www.obd2tool.com would update tech 2 scanner tested reports, which GM Tech2 was used to program transmission control module (TCM) for my Buick Enclave…
Is it OK to get a clone GM Tech2
Is it OK to get a clone GM Tech2 from Obd2tool.com? Work as a real Tech 2? I hope this review can help someone with…
SAAB can’t start after Heat Engine Flameout
Fault: A SAAB car has run about 50 thousand km. After the heat engine flameout the car couldn’t start again. Check: After testing, the starting…
(Review) How do I use GM TECH2 to replace Opel Corsa C ECU
This article is just sharing real experience when use GM Tech2. Hope this helps someone. I decided to invest in some tools to diagnose my…
China GM TECH 2 does everything a real Tech 2 does, how?
China GM TECH 2 does everything a real Tech 2 does, how? 10-06-2014 Update: I just placed my order GM TECH2 which is the complete…
(Review) How do I use GM TECH2 to replace Opel Corsa C ECU
This article is just sharing real experience when use GM Tech 2. Hope this helps someone. I decided to invest in some tools to diagnose…
Does GM tech2 Support Coding?
The tech2 and CANDI module worked perfect to diagnose my bad HVAC air door actuator. I have an older HP laptop running win7 and it…
What is a Drive Cycle in OBD-II?
Drive Cycles are a warm up sequence that the vehicle must complete to allow conditions for all of the onboard tests. When codes are cleared,…